Modifying Policy Servers; Modifying Ldap Policy Server Parameters; Disabling The Policy Server From Downloading Policies - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Omniswitch 6600 series

Hide thumbs Also See for OmniSwitch 6600 Family:

Table of Contents

Modifying Policy Servers

Policy servers are automatically configured when the server is installed; however, policy server parame-

ters may be modified if necessary.

Note. SSL configuration must be done manually through the policy server command.

Use the policy server command to modify parameters for an LDAP policy server.

Keywords for the command are listed here:

Policy server keywords

For information about policy server parameter defaults, see

Policy servers may be prevented from downloading policies to the switch. By default, policy servers are

enabled to download policies.

To disable a server, use the policy server command with the admin keyword and down option.

-> policy server 10.10.2.3 admin down

In this example, an LDAP server with an IP address of 10.10.2.3 will not be used to download policies.

Any policies already downloaded to the switch are not affected by disabling the server.

To re-enable the server, specify up.

-> policy server 10.10.2.3 admin up

The server is now available for downloading policies.

To delete a policy server from the configuration, use the no form of the command with the relevant IP

-> no policy server 10.10.2.3

If the policy server is not created on the default port, the no form of the command must include the port

number. For example:

-> no policy server 10.10.2.4 5000

OmniSwitch 6600 Family Network Configuration Guide

Managing Policy Servers

"Policy Server Defaults" on page

Show Quick Links

Table of Contents