Displaying A List Of Rmon Events; Displaying A Specific Rmon Event - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Diagnosing Switch Problems

Displaying a List of RMON Events

RMON Events are actions that occur based on Alarm conditions detected by an RMON probe. To view a
list of logged RMON Events, enter the
for a particular probe, such as:
-> show rmon events
A display showing all logged RMON Events should appear, as shown in the following example:
Entry Time
---------+----------------+-----------------------------------------------------
1 00:08:00
2 00:26:00
3 00:39:00
The display shown above identifies the Entry number of the specified Event, along with the elapsed time
since the last change in status (measured in hours/minutes/seconds) and a description of the Alarm condi-
tion detected by the probe for all RMON Logged Events. For example, Entry number 3 is linked to ether-
StatsCollisions.2008: [Rising trap] "Rising Event," an Alarm condition detected by the RMON probe in
which a trap was generated based on a Rising Threshold Alarm, with an elapsed time of 39 minutes since
the last change in status.

Displaying a Specific RMON Event

To view information for a specific logged RMON Event, enter the
ing an entry number (event number) for a particular probe, such as:
-> show rmon events 3
A display showing the specific logged RMON Event should appear, as shown in the following example:
Entry Time
---------+----------------+-----------------------------------------------------
3 00:39:00
The display shown above identifies the Entry number of the specified Event, along with the elapsed time
since the last change in status (measured in hours/minutes/seconds) and a description of the Alarm condi-
tion detected by the probe for the specific RMON Logged Event. For example, Entry number 3 is linked to
etherStatsCollisions.2008: [Rising trap] "Rising Event," an Alarm condition detected by the RMON probe
in which a trap was generated based on a Rising Threshold Alarm, with an elapsed time of 39 minutes
since the last change in status.
OmniSwitch 6600 Family Network Configuration Guide
show rmon events command without specifying an entry number
Description
etherStatsPkts.4008: [Falling trap] "Falling Event"
etherStatsCollisions.2008: "Rising Event"
etherStatsCollisions.2008: "Rising Event"
Description
etherStatsCollisions.2008: "Rising Event"
April 2006
Remote Monitoring (RMON)
show rmon events command, specify-
page 27-31