Alcatel OmniSwitch 6600 Family Network Configuration Manual page 133

Using 802.1s Multiple Spanning Tree
In the above 1x1 mode example:
Both switches are running in the 1x1 mode (one Spanning Tree instance per VLAN).
•
VLAN 100 and VLAN 200 are each associated with their own Spanning Tree instance.
•
The connection between 3/1 and 2/1 is left in a forwarding state because it is part of the VLAN 100
•
Spanning Tree instance and is the only connection for that instance.
Note that if additional switches containing a VLAN 100 were attached to the switches in this diagram,
the 3/1 to 2/1 connection could also go into blocking if the VLAN 100 Spanning Tree instance deter-
mines it is necessary to avoid a network loop.
The connections between 4/8 and 5/2 and 4/2 and 5/1 are seen as redundant because they are both
•
controlled by the VLAN 200 Spanning Tree instance and connect to the same switches. The VLAN
200 Spanning Tree instance determines which connection provides the best data path and transitions
the other connection to a blocking state.
In the above flat mode STP/RSTP example:
Both switches are running in the flat mode. As a result, a single flat mode Spanning Tree instance
•
applies to the entire switch and compares port connections across VLANs to determine which connec-
tion provides the best data path.
The connection between 3/1 and 2/1 is left forwarding because the flat mode instance determined that
•
this connection provides the best data path between the two switches.
The 4/8 to 5/2 connection and the 4/2 to 5/1 connection are considered redundant connections so they
•
are both blocked in favor of the 3/1 to 2/1 connection.
OmniSwitch 6600 Family Network Configuration Guide
3/1
VLAN 100
4/2
VLAN 200
||
4/8
1x1 Mode STP/RSTP
3/1
VLAN 100
4/2
||
VLAN 200
||
4/8
Flat Mode STP/RSTP (802.1D/802.1w)
April 2006
2/1
VLAN 100
5/1
VLAN 200
5/2
2/1
VLAN 100
5/1
VLAN 200
5/2
MST General Overview
page 6-5