Alcatel OmniSwitch 6600 Family Network Configuration Manual page 109

Configuring Spanning Tree Parameters
Note that explicit commands using the cist and msti keywords are required to define an MSTP (802.1s)
configuration. Implicit commands are only allowed for defining STP or RSTP configurations. See
Chapter 6, "Using 802.1s Multiple Spanning Tree,"
implicit and explicit commands.
The following is a summary of Spanning Tree bridge configuration commands. For more information
about these commands, see the OmniSwitch CLI Reference Guide.
Commands
bridge protocol
bridge cist protocol
bridge 1x1 protocol
bridge priority
bridge cist priority
bridge msti priority
bridge 1x1 priority
bridge hello time
bridge cist hello time
bridge 1x1 hello time
bridge max age
bridge cist max age
bridge 1x1 max age
bridge forward delay
bridge cist forward delay
bridge 1x1 forward delay
bridge bpdu-switching
OmniSwitch 6600 Family Network Configuration Guide
for more information about these keywords and using
Type Used for ...
Implicit Configuring the protocol for a VLAN instance when the
1x1 mode is active or the single Spanning Tree instance
when the flat mode is active.
Explicit Configuring the protocol for the single flat mode instance.
Explicit Configuring the protocol for a VLAN instance.
Implicit Configuring the priority value for a VLAN instance or the
flat mode instance.
Explicit Configuring the priority value for the single flat mode
instance.
Explicit Configuring the protocol for an 802.1s Multiple Spanning
Tree Instance (MSTI).
Explicit Configuring the priority value for a VLAN instance.
Implicit Configuring the hello time value for a VLAN instance
when the 1x1 mode is active or the single Spanning Tree
instance when the flat mode is active.
Explicit Configuring the hello time value for the single flat mode
instance.
Explicit Configuring the hello time value for a VLAN instance.
Implicit Configuring the maximum age time value for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
Explicit Configuring the maximum age time value for the single
flat mode instance.
Explicit Configuring the maximum age time value for a VLAN
instance.
Implicit Configuring the forward delay time value for a VLAN
instance when the 1x1 mode is active or the single Span-
ning Tree instance when the flat mode is active.
Explicit Configuring the forward delay time value for the single
flat mode instance.
Explicit Configuring the forward delay time value for a VLAN
instance.
N/A Configuring the BPDU switching status for a VLAN.
April 2006
Configuring Spanning Tree Bridge Parameters
page 5-13