Configuring QoS
Using Map Groups
Map groups are used to map 802.1p, ToS, or DSCP values to different values. On the OmniSwitch 6600,
the following mapping scenarios are supported:
802.1p to 802.1p
•
ToS or DSCP to 802.1p (the reverse is not supported)
•
Note. Map groups are associated with a policy action.
Commands used for creating map groups include the following:
policy map group
policy action map
Sample Map Group Configuration
1
Create the map group with mapping values. For detailed information about map groups and how to set
them up, see
"How Map Groups Work" on page 24-44
-> policy map group tosGroup 1-2:5 4:5 5-6:7
2
Attach the map group to a policy action. See
mation about creating policy actions.
-> policy action tosMap map tos to 802.1p using tosGroup
Note. (Optional) Use the show policy map group command to verify the map group.
-> show policy map group
Group Name
+tosGroup
For more information about this command, see
the OmniSwitch CLI Reference Guide.
3
Attach the action to a policy rule. In this example, the condition Traffic is already configured. For
more information about configuring rules, see
-> policy rule r3 condition Traffic action tosMap
4
Apply the configuration. For more information about this command, see
on page
24-46.
-> qos apply
OmniSwitch 6600 Family Network Configuration Guide
and
"Creating Map Groups" on page
"Creating Policy Actions" on page 24-25
From Entries
cli 1-2:5
4:5
5-6:7
"Verifying Map Group Configuration" on page 24-45
"Creating Policy Rules" on page
April 2006
Using Map Groups
24-44.
for more infor-
24-26.
"Applying the Configuration"
page 24-43
and