Configuring Dynamic Vlan Port Assignment - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Dynamically Assigning Ports to VLANs
VLAN 1
Default VLAN
Port 1
130.0.0.1
Dynamic VPA
Default VLAN

Configuring Dynamic VLAN Port Assignment

Dynamic VLAN port assignment requires the following configuration steps:
1 Use the vlan port mobile
VLAN assignment. See
2 Enable/disable mobile port properties that determine mobile port behavior. See
Port Properties" on page 7-16
3 Create VLANs that will receive and forward mobile port traffic. See
for more information.
4 Configure the method of traffic classification (VLAN rules or tagged VLAN ID) that will trigger
dynamic assignment of a mobile port to the VLANs created in Step 3. See
page 7-8 and "VLAN Mobile Tag Classification" on page 7-5
Once the above configuration steps are completed, dynamic VLAN assignment occurs when a device
connected to a mobile port starts to send traffic. This traffic is examined by switch software to determine
which VLAN should carry the traffic based on the type of classification, if any, defined for a particular
VLAN. See "Dynamically Assigning Ports to VLANs" on page 7-4
dynamic VLAN port assignment.
page 7-10
VLAN 2
Network 130.0.0.0
IP
Port 2
138.0.0.1
Mobile Port Traffic Triggers Dynamic VLAN Assignment
command to enable mobility on switch ports that will participate in dynamic
"Enabling/Disabling Port Mobility" on page 7-11
for detailed procedures.
OmniSwitch 6600 Family Network Configuration Guide
VLAN 4
Network 140.0.0.0
IP
VLAN 3
Network 138.0.0.0
IP
140.0.0.1
Chapter 4, "Configuring VLANs,"
for more information.
for more information and examples of
Assigning Ports to VLANs
OmniSwitch
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
Port 3
for detailed procedures.
"Configuring Mobile
"VLAN Rule Classification" on
April 2006