Quick Steps For Setting Up Dhcp Relay - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Quick Steps for Setting Up DHCP Relay

Quick Steps for Setting Up DHCP Relay
You should configure DHCP Relay on switches where packets are routed between IP networks.
There is no separate command for enabling or disabling the relay service. DHCP Relay is automatically
enabled on the switch whenever a DHCP server IP address is defined. To set up DHCP Relay, proceed as
follows:
1 Identify the IP address of the DHCP server. Where the DHCP server has IP address 128.100.16.1, use
the following command:
-> ip helper address 128.100.16.1
2
Set the forward delay timer for the BOOTP/DHCP relay. To set the timer for a 15 second delay, use the
following command:
-> ip helper forward delay 15
3 Set the maximum hop count value. To set a hop count of 3, use the following command:
-> ip helper maximum hops 3
Note. Optional. To verify the DHCP Relay configuration, enter the
shown for the DHCP Relay configured in the above Quick Steps is shown here:
-> show ip helper
Forward Delay (seconds) = 15
Max number of hops
Forward option
Forwarding Address:
128.100.16.1
For more information about this display, see the "DHCP Relay" chapter in the OmniSwitch CLI Reference
Guide.
page 18-4
= 3
= standard
OmniSwitch 6600 Family Network Configuration Guide
Configuring DHCP Relay
show ip helper command. The display
April 2006