Switch Health Defaults; Quick Steps For Configuring Switch Health - Alcatel OmniSwitch 6600 Family Network Configuration Manual

Diagnosing Switch Problems

Switch Health Defaults

The following table shows Switch Health default values.
Global Switch Health Defaults
Parameter Description
Resource Threshold Limit Configuration
Sampling Interval Configuration
Switch Temperature

Quick Steps for Configuring Switch Health

1
Display the health threshold limits, health sampling interval settings and/or health statistics for the
switch, depending on the parameters you wish to modify. (For best results, note the default settings for
future reference.) For example:
-> show health threshold
The default settings for the command you entered will be displayed. For example:
Rx Threshold
TxRx Threshold
Memory Threshold
CPU Threshold
Temperature Threshold
2 Enter the appropriate command to change the desired health threshold or health sampling interval
parameter settings, or reset all health statistics for the switch. For example:
-> health threshold memory 85
Note. Optional. To verify the Switch Health configuration, enter
parameter you modified (e.g., memory). The display is similar to the one shown below:
Memory Threshold
For more information about this command, see
the "Health Monitoring Commands" chapter in the OmniSwitch CLI Reference Guide.
OmniSwitch 6600 Family Network Configuration Guide
CLI Command
health threshold
health interval
health interval
= 80
= 80
= 80
= 80
= 50
= 85
"Displaying Health Threshold Limits" on page 27-35
April 2006
Switch Health Overview
Default Value/Comments
80 percent
5 seconds
50 degrees Celsius
show health threshold followed by the
or
page 27-11