Alcatel OmniSwitch 6600 Family Network Configuration Manual page 555

Configuring ACLs
To display only policy rules that are active (enabled) on the switch, use the show active policy rule
command. For example:
-> show active policy rule
+my_rule5
Cnd/Act:
mac1
Cnd/Act:
In this example, the rule my_rule does not display because it is inactive. Rules are inactive if they are
administratively disabled through the policy rule command, or if the rule cannot be enforced by the
current hardware. Both my_rule5 and mac1 are displayed here because they are active; however,
my_rule5 is a pending rule and will not be used to classify traffic until the qos apply command is entered.
See the OmniSwitch CLI Reference Guide for more information about the output of these commands.
OmniSwitch 6600 Family Network Configuration Guide
Policy From Prec
cli
cond2 -> pri2
cli
dmac1 -> pri2
Enab Inact Refl Log Save
0 Yes No No
0 Yes No No
April 2006
Verifying the ACL Configuration
Matches
No Yes
No Yes
page 25-23
0
0