Table of Contents
Advertisement
RIP Redistribution
3
Configuring a RIP Redistribution Filter
– Creating a Filter
– Configuring a Redistribution Filter Action (optional)
– Configuring a Redistribution Metric (optional).
Enabling RIP Redistribution
Use the
ip rip redist status
bution you would enter:
-> ip rip redist status enable
RIP redistribution is disabled by default.
Use the ip rip redist status disable command to disable redistribution. Use the show ip rip command to
display RIP redistribution status.
Configuring a RIP Redistribution Policy
After enabling RIP redistribution, configure a policy that defines the route types that will be redistributed
into RIP. Only the route types you configure will be redistributed into RIP. When you configure a redistri-
bution policy, RIP is automatically enabled.
Use the
ip rip redist
then enter the route type. For example, to redistribute OSPF routes into RIP you would enter:
-> ip rip redist ospf
The redistribution route types are:
local. Redistribute local routes into RIP.
•
static. Redistribute static routes into RIP.
•
ospf. Redistribute routes learned through OSPF into RIP.
•
Use the no ip rip redist command to delete a redistribution policy. For example, to "turn off" redistribu-
tion of OSPF routes you would enter:
-> no ip rip redist ospf
Note. If you are configuring more than one route type, you must repeat the command for each one.
Use the
show ip rip redist
page 16-10
command to enable/disable redistribution. For example, to enable RIP redistri-
command to define the route types that will be redistributed. Enter the command,
command to display the status of RIP policies.
OmniSwitch 6600 Family Network Configuration Guide
Configuring RIP
April 2006
Hide quick links:
Advertisement
Table of Contents
