Concluding Steps - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

10.3.1.4 Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 59.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable TPM in the system board BIOS. Proceed as follows:
Ê Open a virtual console for your server blade as describe in section
"Launching a video redirection to a server blade" on page
Ê Switch on or restart your server blade.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
Ê Select the Advanced menu.
Ê Select the Trusted Computing submenu.
Ê Set the TPM Support and TPM State settings to Enabled.
Ê Under Pending TPM operation, select the desired TPM operation mode.
Ê Save your changes and exit the BIOS.
I
For detailed information on how to access the BIOS and modify
settings, refer to the "D3142 BIOS Setup Utility for PRIMERGY
BX920 S3" reference manual available online at
http://manuals.ts.fujitsu.com
supplied with your PRIMERGY server.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
BX920 S3
65.
Upgrade and Maintenance Manual
System board components
"Closing the server blade" on
or from the ServerView Suite DVD 2
96.
60.
"Closing the rack
67.
"Enabling
231