10.2.1.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page
59.
Ê Reinstall and secure it in the system unit as described in section
the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
10.2.1.5 Software configuration
The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server blade.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.
BX920 S3
65.
Upgrade and Maintenance Manual
System board components
"Closing the server blade" on
60.
89.
96.
"Installing
"Closing the rack
"Enabling boot
"Enabling
219