Removing The Ufm; Concluding Steps - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

10.2.2.3 Removing the UFM

Ê Remove the nylon screw from the defective UFM.
Figure 90: Removing the UFM
Ê Grasp the UFM on its corners (see arrows), then pull ouit t gradually and
carefully.
The UFM spacer remains on the system board.

10.2.2.4 Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 59.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
BX920 S3
65.
Upgrade and Maintenance Manual
System board components
"Closing the server blade" on
96.
60.
"Closing the rack
"Enabling
221