Replacing Hdd/Ssd Backplanes; Required Tools; Preliminary Steps - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

6.5

Replacing HDD/SSD backplanes

Field Replaceable Units (FRU)
Average hardware task duration: 15 minutes
Average software task duration: 5 minutes
6.5.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the SAS backplane:
●
– Phillips PH2 / (+) No. 2 screw driver
6.5.2

Preliminary steps

Before replacing a HDD/SSD backplane, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server blade as described in section
defective server blade" on page
Ê Shut down the server blade as described in section
server blade" on page
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page
Ê Open the server blade as described in section
on page 58.
Ê Remove the HDD/SSD module from the relevant bay as described in section
"Removing the 2.5-inch HDD/SSD module" on page
BX920 S3
70.
54.
55.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
47.
"Opening the server blade"
"Disabling BitLocker
"Opening the rack
"Locating the
"Shutting down the
57.
109.
113