Installing Mezzanine Cards; Required Tools; Preliminary Steps - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

Expansion cards and backup units
7.1.2

Installing mezzanine cards

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
7.1.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing mezzanine cards: tool-less
●
7.1.2.2

Preliminary steps

Before installing an expansion card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server blade as described in section
defective server blade" on page
Ê Shut down the server blade as described in section
server blade" on page
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page
Ê Open the server blade as described in section
on page 58.
Ê When installing a SAS Expander mezzanine card make sure, that an SAS
RAID HDD module is installed as described in section
RAID HDD module" on page
130
70.
54.
47.
55.
144.
Upgrade and Maintenance Manual
71.
"Opening the server blade"
"Disabling BitLocker
"Disabling boot
"Opening the rack
"Locating the
"Shutting down the
57.
"Installing the SAS
BX920 S3