After Replacing The Server Blade; Switching Off The Id Indicator - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

Basic software procedures
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the LAN/CNA controller.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I
For details, refer to the relevant LAN/CNA driver manual.

5.2.18.2 After replacing the server blade

Ê Confirm with the customer whether the onboard CNA controller you have
replaced has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the CNA driver utility after replacing the server blade.
I
For details, refer to the relevant CNA driver manual.

5.2.19 Switching off the ID indicator

Press the ID button on the front panel or use management blade web interface
to switch off the ID indicator after the maintenance task has been concluded
successfully.
I
For further information, refer to section
blade" on page
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch off the ID indicator.
Using management blade web interface
Ê In management blade web interface press the Locate button in the status
frame to switch on the ID indicator.
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View and press the Locate
button in the title bar to switch off the ID indicator.
100
47.
Upgrade and Maintenance Manual
"Locating the defective server
BX920 S3