Removing The Sas Raid Hdd Module; Concluding Steps - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual

7.2.3.3

Removing the SAS RAID HDD module

I
The following procedure is identical for both variants of SAS RAID HDD
modules.
Figure 47: Removing the SAS RAID HDD module
Ê Remove the SAS RAID HDD module together with the riser card from the
system board.
7.2.3.4

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 59.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
BX920 S3
89.
96.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Closing the server blade" on
60.
"Enabling boot
"Enabling
149