Connection Of Dc Power Cable; Figure 2-29 Pwr Cnt Ca-D/Pwr Cnt Ca-E; Figure 2-30 Cable Connection Between Pz-Pw121 And Bwb - NEC NEAX 2000IVS2 Installation Manual

Connection of DC Power Cable

(1) Confirm the connection of power output cables, as shown below (These cables are pre-
installed).
(2) For PIM0, connect the PWR CNT CA-E to the CN103 connector on the PZ-PW121 card and
the PWR1 connector on the BWB.
For PIM1 to PIM7, connect the PWR CNT CA-D to the CN103 connector on the PZ-PW121
card and the PWR1 connector on the BWB.

Figure 2-30 Cable Connection between PZ-PW121 and BWB

PZ-PW121
CN103
PWR CNT CA-E (FOR PIM0)
PWR CNT CA-D (FOR PIM1 TO PIM7)
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0

Figure 2-29 PWR CNT CA-D/PWR CNT CA-E

250 mm (9.8 inch)
550 mm (21.7 inch)
PWR1
PWR0A
PWR0B
PWR0C
POWER OUTPUT CABLE (+90V, CR, E)
300 mm (11.8 inch)
PIM
BWB (BACK WIRING BOARD)
CARD SLOT AREA
LTC CONNECTOR AREA
POWER OUTPUT CABLE (+5V, -27V, E)
CHAPTER 2 INSTALLATION
Connection of DC Power Cable
Page 85