NEC NEAX 2000IVS2 Installation Manual page 228

CHAPTER 2 INSTALLATION
System Data Entry
SYSTEM DATA ENTRY
There are two methods for data entry, using a Customer Administration Terminal
(CAT) or a Maintenance Administration Terminal (MAT).
NOTE: For assigning system data, refer to the Command Manual.
CAT
term
Any D can be assigned as a CAT through programming. The D
ular telephone when it is not in CAT mode. If the system is initialized by "C" (Resident System
term
Program), every D
Clear), only LEN000 is assigned as a CAT port (the DLC card must be installed in slot LT00).
term
To use a D as a CAT, follow the procedures shown below.
NOTE: It is necessary to complete steps 1 through 6 within 4 seconds.
To set CAT mode:
TRF
1. Press
CNF
2. Press
- CNF/Conf lamp flashes
3. Press *
- CNF/Conf lamp is off
TRF
4. Press
CNF
5. Press
- CNF/Conf lamp flashes
#
6. Press
- CNF/Conf, SPKR/Speaker, FNC/Feature lamps are lit
- "CAT MODE" is displayed on the LCD
LNR/SPD
7. Press
- "COMMAND = -" is displayed on the LCD
Page 202
will be able to go into CAT mode. If the system is initialized by "B" (All
Transfer
or
Conf
or
Transfer
or
Conf
or
Redial
or
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
term
can still be used as a reg-
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0