Figure 2-20 Hanging Pim To Hanger Assem - NEC NEAX 2000IVS2 Installation Manual

CHAPTER 2 INSTALLATION
Wall Mounting Installation
• Hanging PIM to HANGER ASSEM
(1) Secure the HANGER ASSEM to the surface of a wall with three screws.
Select screws to match with the wall type as follows.
WALL TYPE
CONCRETE
WOOD
PLASTER BOARD
[THICKNESS Min. 9.6 mm (0.38 inch)]
A concrete wall is recommended because it is the most firm to mount the PBX of the
three. The plaster board is the least firm wall of the three.
(2) Hang the slits of the rear of a PIM to the hooks of the HANGER ASSEM.
(3) Secure the PIM to the HANGER ASSEM with two screws.
NOTE: Screws are attached to the HANGER ASSEM.
SCREWS
Page 74
ANCHOR BOLT TYPE
WOOD TYPE SCREWS
MOLLY ANCHOR TYPE

Figure 2-20 Hanging PIM to HANGER ASSEM

FRONT
RECOMMENDED SCREW
Recommended 4 mm (0.16 inch) by
25 mm (0.98 inch)
Min. 3.5 mm (0.14 inch) DIA
Max. 4.5 mm (0.17 inch) DIA
Min. 3.5 mm (0.14 inch) DIA
Max. 4.5 mm (0.17 inch) DIA
HOOK
PIM
BASE
NEAX2000 IVS
HANGER ASSEM
HOOK
2
Installation Procedure Manual
ND-70928 (E), Issue 1.0