CHAPTER 2 INSTALLATION
Mounting Circuit Cards
(3) Fix the CARD STOPPER according to the following procedure.
STEP 1: After mounting all circuit cards slide the CARD STOPPER to the left.
STEP 2: Tighten the screws of the CARD STOPPER as shown below.
NOTE:
When sliding the PIM CARD STOPPER, loosen all of the screws securing the PIM
CARD STOPPER and the PZ-M542/PZ-M557 card (the screws need not to be re-
moved).
Figure 2-106 Installation of the CARD STOPPER
Page 200
CIRCUIT CARD
CIRCUIT CARD
SLIDE THE CARD
SCREW
STOPPER TO THE LEFT.
CARD
STOPPER
SCREW
CARD
STOPPER
2
NEAX2000 IVS
Installation Procedure Manual
ND-70928 (E), Issue 1.0