Pn-24Prta Prt; Pn-4Rstb Mfr; Pn-4Rstc Cir; Pn-Sc00 Cch - NEC NEAX 2000IVS2 Installation Manual

CHAPTER 1 GENERAL INFORMATION
Application Processor Card
Table 1-4 Application Processor Card Name and Function (Continued)
EQUIPMENT FUNCTIONAL
NAME
PN-IPTA IPT
PN-24PRTA PRT
PN-4RSTB MFR
PN-4RSTC CIR
PN-SC00 CCH
PN-SC01 DCH
PN-SC03 ICH
PN-SC03-A CSH
Page 18
NAME
IP Trunk Card
Accommodates the IP network and transmit/receive com-
pressed voice or signals over IP network.
Used with max. four PN-4VCTH cards (16 channels).
10 BASE-T/100 BASE-TX twisted pair cable is connected
directly to this card.
ISDN Primary Rate (23B+D) Interface Card
Provides a built-in D-channel Handler (DCH).
4-line MF Receiver, MFC Receiver/Sender Card
Used for MF/MFC-R2 Signaling on DID/DOD trunks.
Max. four cards can be provided per system, including the
PN-4RSTC card.
4-line Caller ID Receiver Trunk Card
Used for Caller ID (CLASS SM) on analog trunks.
Max. four cards per system, including the PN-4RSTB card.
Common Channel Handler Card
Transmits/receives signals on the common signalling channel
of No. 7 CCIS.
D-channel Handler Card
Transmits/receives signals on the D-channel of ISDN Primary
Rate (23B+D) interface or WCS Roaming interface.
ISDN-channel Handler Card
Provides the D-channel signaling interface and controls max.
four ILC cards (Layer 2 and 3).
CS(ZT) Handler Card
Provides the D-channel signaling interface and controls
max. four CSI cards, eight CS(ZT)s.
FUNCTION
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0