NEC NEAX 2000IVS2 Installation Manual page 25

Before installing the equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using
an acceptable method of connection. In some cases, the company's inside wiring associated with
a single line individual service may be extended by means of a certified connector assembly
(telephone extension cord). The customer should be aware that compliance with the above con-
ditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or installations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request that the
user disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines, and internal metallic water pipe system, if present, are connected togeth-
er. This protection may be particularly important in rural areas.
Users should not attempt to make such connections themselves, but should contact the appro-
priate electric inspection authority, or electrician, as appropriate.
NOTICE: The Load Number assigned to each terminal device denotes the percentage of the total
load to be connected to a telephone loop which is used by the device, to prevent overloading.
The termination on a loop may consist of any combination of devices subject only to the require-
ment that the total of the load numbers of all the devices does not exceed 100.
2
NEAX2000 IVS Installation Procedure Manual
ND-70928 (E), Issue 1.0
CAUTION
REGULATORY INFORMATION
Industry Canada CS-03
Page xvii