• Drilling
(1) Make a preliminary hole in the concrete, using a drill bit for small-diameter holes.
(2) Drill a hole in the concrete with a drill suitable for a plug bolt a little deeper than the plug
bolt length.
Anchor Bolt Size : 10mm (0.39 inch)
(3) Insert the anchor bolt into the hole.
(4) Push anchor bolt until the bolt stays permanently in place.
(5) Turn bolt counterclockwise and remove.
(6) Insert bolts correctly into the holes for equipment installation, then tighten them properly.
Figure 2-11 Drilling Instructions for Anchor Bolt
(1)
2
NEAX2000 IVS
Installation Procedure Manual
ND-70928 (E), Issue 1.0
6mm (0.24 inch)
(2)
(3)
CHAPTER 2 INSTALLATION
DIA for Fixed Equipment
DIA for Stationary Equipment
(4)
(5)
Floor Standing Installation
(6)
Page 59