Wall Mounting; Figure 7-60 Positioning The Handset Hanger - NEC Xen Master System Hardware Manual

System Hardware Manual
3.10

Wall Mounting

Any DTU-type Multiline Terminal can be mounted on a wall.
Multiline Terminals can be wall mounted by using the base unit that
comes with the Multiline Terminal or by using the WMU-UA Unit to
accommodate adaptors that are installed on the Multiline Terminal.
3.10.1 Removing and Remounting the Handset Hanger
1.
2.
þ

Figure 7-60 Positioning the Handset Hanger

Remove the hanger by sliding it out of the slot.
Install it back in its original position so that the hanger
protrudes providing a rest for the handset. (This
procedure applies when using either the base unit or
the WMU-UA Unit.) Refer to Figure 7-60 Positioning
the Handset Hanger for the steps for removing and
remounting the handset hanger.
À
Ã
May 2001
7 - 231