Video Output Formats; Dip Switch Settings For Video Output Formats; Line Voltage Frequency - TANDBERG Profile 42” Manual

Profile
Contents Introduction
Contents Introduction
The PrecisionHD 1080p camera,
cont...

Video output formats

This section describes the video output formats for the TANDBERG
PrecisionHD 1080p camera.

DIP switch settings for video output formats

The video output format for the camera is set by DIP switches. The
DIP switches are found on the bottom side of the camera.
The default setting is Auto. When using HDMI, the video output format
is automatically detected. See the table to the right.
Maximum resolution for HDMI is 1080p60.
Maximum resolution for HD-SDI is 1080p30.

Line voltage frequency

The camera will automatically detect the line voltage frequency when it
is 50 or 60 Hz. You may set the video output format to a specific value
(use the DIP switches) to override the auto frequency detection, if a
different line voltage frequency is an issue.
D14324.03—AUGUST 2009
Getting started About the menus
Getting started About the menus
The DIP switch
Bottom side of the TANDBERG
PrecisionHD 1080p camera
The Settings menu The Settings library
The settings menu Settings Library
1
0
Administrator Guide
Cameras Cameras Appendices
Cameras Appendices
DIP Switch table for video formats
1 2 3 4 5 HDMI
0 0 0 0 0
0 0 0 0 1 1920x1080p25
0 0 0 1 0 1920x1080p30
0 0 0 1 1 1920x1080p50
0 0 1 0 0 1920x1080p60
0 0 1 0 1 1280x720p25
0 0 1 1 0 1280x720p30
0 0 1 1 1 1280x720p50
0 1 0 0 0 1280x720p60
0 1 0 0 1 Software control
The table shows the different settings available for the HDMI and
the HD-SDI outputs.
Auto: Camera negotiates format over HDMI. HD-SDI tracks HDMI
and defaults to 1080p30 in absence of HDMI sync.
Software: For more on the Software control setting, read about
video mode selections in the TANDBERG PrecisionHD 1080p User
Guide.
Contact us
Contact us
HD-SDI
Auto
1920x1080p25
1920x1080p30
1280x720p50
1280x720p60
1280x720p25
1280x720p30
1280x720p50
1280x720p60
48