Systemunit; Telnet; Timezone; Traversal - TANDBERG Gatekeeper User Manual

16.2.18.

SystemUnit

xconfiguration SystemUnit Name: <name>
The name of the unit. Choose a name that uniquely identifies the system.
xconfiguration SystemUnit Password: <password>
Specify the password of the unit. The password is used to login with Telnet, HTTP(S), SSH, SCP, and on
the serial port.
Note: To set an empty password type
xconfiguration SystemUnit Password: ""
16.2.19.

Telnet

xconfiguration Telnet Mode: <On/Off>
Enables/disables Telnet support.
You must restart the system for changes to take effect.
Note: For secure operation you should use SSH in preference to Telnet.
16.2.20.

TimeZone

xconfiguration TimeZone Name: <timezone_name>
Sets the local time zone. Time zone names follow the POSIX naming convention e.g. Europe/London or
America/New_York.
16.2.21.

Traversal

xconfiguration Traversal Registration RetryInterval: <1..65534>
Sets the interval in seconds at which the Gatekeeper will attempt to register with the Border Controller if
its initial registration fails for some reason. The default is 120 seconds.
xconfiguration Traversal AllowMediaDirect: <On/Off>
Determines whether endpoints must route their media through the Gatekeeper or may, if capable, send
media directly to the Border Controller.
16.2.22.

Zones

Traversal zones control how the Gatekeeper communicates with a Border Controller with which it is
cooperating to provide firewall traversal.
xconfiguration Zones TraversalZone Name: <name>
Sets the name of the traversal zone.
xconfiguration Zones TraversalZone Gatekeeper Address: <IPAddress>
Sets the IP address of the Border Controller that this system will register with.
xconfiguration Zones TraversalZone Gatekeeper HopCount: <1..255>
Specifies the hop count to be used when originating an LRQ.
TANDBERG Gatekeeper User Guide
Page 81 of 105