Table of Contents
Advertisement
Applications
AUTO Layout
Use this function to detect the image area of the original on the platen glass and center
the whole image on the copy paper.
Use platen glass. (RADF cannot be used.)
Copy mode is automatically set to 1-1 mode; 1-2 mode is also available only when using
Platen store mode.
APS and AMS are automatically released. Changing Magnification is available.
Non-image area erase is automatically selected (can be released manually).
Incompatible Basic Copying Conditions: Using RADF, 2-2, 2-1, APS, AMS
Incompatible Output Modes: Staple
Incompatible Applications: Sheet/Cover Insertion, Chapter, Combination, Booklet, Image Insert,
Special Original (Mixed Original, Folded Original, Non-Standard Size, Upside Down), Reverse
Image, Repeat, Image Shift, STAMP/OVERLAY
NOTE: The AUTO layout function may not operate properly if the lighting in the work place is directly over the
platen glass. In this case, consult your service representative about an appropriate place for
installation.
Set original
1 Press [
APPLICATION
2 Touch
AUTO Layout
3 Make additional application selections, or touch
4 APS and AMS are automatically released. Select the desired copy size and
magnification.
5 Enter the desired print quantity from the control panel keypad.
6 Position original FACE DOWN on the platen glass.
IMPORTANT: DO NOT CLOSE THE DOCUMENT FEEDER. PLACING ORIGINAL
OBLIQUELY ON THE PLATEN GLASS MAY CAUSE BLACK COPY MARKS.
Option: Press [CHECK] to view the selection, and make the Proof copy, if desired; then touch EXIT to return
to the Basic Screen. See p. 6-29 to p. 6-30.
7 Press [
].
START
After copying is completed, press [
machine.
AUTO layout copying
] on the control panel to display the Application Selection Screen.
.
AUTO RESET
Application Selection Screen
to return to the Basic Screen.
OK
] to release the mode and reset the
Applications 8-39
Advertisement
Table of Contents
Troubleshooting
