Konica Minolta 7045 User Manual page 62

Basic Operations
How to Make a Basic Copy (continued)
The Basic Screen (continued)
1 Check that the main power switch on the rear-left side of the copier is turned on,
then turn on the power switch at the far left of the control panel. The Basic Screen
will be displayed.
The machine takes approximately 30 seconds to go through a warm-up.
2 Set the copying conditions, as required.
3 Enter the desired print quantity from the control panel keypad. The entered quantity
will be displayed on the upper right message area of the Basic Screen.
To change the print quantity, press [C] (
NOTE: Do not press [STOP/CLEAR]; otherwise the scanned image may be cleared.
4 Position the original document FACE UP in the document feeder or FACE DOWN on
the platen glass.
HINTS:
1 For details on positioning originals, see p. 4-2 and p. 4-4.
2 For original and copy paper information, see Section 4.
5 Press [
START
Memory indicator on the upper right of the Basic Screen allows you to check the
remaining memory.
Printing job starts in succession when the machine becomes ready for output.
To suspend the scanning or printing job and delete all the data, press [
After copying is completed, all the scanned data will be deleted automatically.
Press [
AUTO RESET
Basic Copy Settings on Basic Screen
Copy mode
Copy density
Lens mode
Copy size
Reserve and Job list
Store mode
Rotation
Check mode and Proof copy : see p. 6-29 ~ p. 6-30
Interrupt mode
Help mode
Section 7 describes how to select Output modes.
Section 8 describes how to select Application functions.
Section 10 describes shortcuts of basic and applicaton operating.
] to scan.
] to release the mode and reset the machine.
: see p. 6-4 ~ p. 6-6
: see p. 6-7
: see p. 6-8 ~ p. 6-14
: see p. 6-15 ~ p. 6-16
: see p. 6-17 ~ p. 6-22
: see p. 6-23 ~ p. 6-25
: see p. 6-26 ~ p. 6-28
: see p. 6-31 ~ p. 6-32
: see p. 6-33
), then enter the correct quantity.
CLEAR QTY.
STOP/CLEAR
Basic Operations 6-3
].