Konica Minolta 7045 User Manual page 31

Safety Information
Machine Handling and Care (continued)
CAUTION:
FAILURE TO HEED THE FOLLOWING CAUTIONS MAY RESULT IN MACHINE DAMAGE,
OVERHEATING, AND/OR PERSONAL INJURY
MACHINE MODIFICATION
Do not modify the machine in any way or remove any part or
screw; and never attempt to perform any maintenance function
that is not specifically described in this manual. Do not connect
the machine with any options other than those specified.
FINISHER OPERATION
DO NOT INSERT your finger into the two staple driving portions
or into the grooves of the paper exit lever, otherwise you may be
injured.
To avoid injury when the Finisher middle exit tray moves up and down, DO NOT PUT
your hand into the two portions of the closing area.
PERIODIC CHECK
Check for loose connection or excessive heat on power plug, dust between power cord
and plug, damage to power cord and/or plug (creased, frayed, scratched or cut, etc.). Be
sure the plug is inserted fully, and ground wire is connected correctly. If any abnormality
occurs, do not continue to operate the machine.
SERVICE MESSAGES
If a service message displays, turn the machine off, disconnect the power cord from the
outlet, and report the condition to your service representative.
TONER
Check to be sure toner in storage is out of the reach of children, or anyone incapable of
using supplies safely. Although toner is nontoxic, do not inhale toner or allow it to come
in contact with eyes. If inhalation or eye contact occurs, immediately consult a physician.
Please refer to the appropriate material safety data sheet for additional toner safety
information.
PAPER
Check paper to be sure it is according to specifications outlined in Section 4.
RADF HINGES
DO NOT INSERT your finger into the two RADF hinge portions, otherwise you may be
injured.
Safety Information 2-9