Konica Minolta 7045 User Manual page 29

Safety Information
Machine Installation and Power Requirements (continued)
CAUTION:
FAILURE TO HEED THE FOLLOWING CAUTIONS MAY RESULT IN MACHINE DAMAGE,
OVERHEATING, RISK OF ELECTRICAL SHOCK, AND/OR PERSONAL INJURY
PLUG SOCKET
A plug socket is limited in capacity. Use an exclusive power source for this machine;
otherwise, an accident from overheating and/or smoking may occur. The total power
consumption of the main body, plus all peripherals, must not exceed the capacity of the
main power supply.
For plug cable equipment, that the socket-outlet shall be installed near the equipment
and shall be easily accessible.
PLUG AND CORD (LEAD)
Unless the power plug is firmly inserted into the socket, an accident from overheating
and/or smoking may occur. Firmly insert the power cord plug into the electrical outlet
before turning on the copier power switch. If the inserted plug is loose in the socket,
disconnect it, and consult an electrician for repair; but, do not attempt to operate the
machine.
For plug cable equipment, be sure that the socket-outlet shall be installed near the
equipment and shall be easily accessible.
A damaged power cord may result in overheating, short circuit or fire. Do not bend,
crush, wind, or kick the cord; or strike it with a desk or any item; or roll up the power
cord. If the main body power cord is bent or damaged, immediately contact your Konica
service representative; and do not attempt to repair it yourself, or continue to operate the
machine.
ADAPTERS AND PLURAL LOADS
Never use adapters; and never connect plural loads or a branched socket to one socket
outlet; otherwise an accident may occur from overheating or fire.
EXTENSION CORDS (LEADS)
An extension cord or lead is limited in capacity. Unless the cord or lead has adequate
capacity, smoking may occur, and an accident may be caused from overheating. Should
smoking and/or overheating occur, contact an electrician immediately. If you require
further information about power requirements, power consumption, extension cords,
adapters and connectors, please contact your Konica service representative, and also
consult your electrician.
Safety Information 2-7