Bag F - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 70
!
Step 1. Inspect the inside of the tires [front (144), rear (145)] for any excess material. If present, trim excess rubber to ensure
proper seating of the tires on the wheels [front (147), rear (148)].
*NOTE: Do not set tires on furniture as they may leave permanent stains.
!
Step 2. Insert foam tire liners (146) into the front tires (144). Pull the front tires (144) over the front wheels (147) so that the angled
ribs are on the solid side of the wheel (outside). Squeeze the tires (144) to properly seat it in the grooves of the wheels (147).
!
Step 3. Insert foam tire liners (146) into the rear tires (145). Pull the rear tires (145) over the rear wheel (148) and squeeze the tire
(145) to properly seat it in the grooves of the wheels (148). Make certain that the foam liners (146) are not pinched between the tires
(145) and the wheels (148).
!
Step 4. The tires (144), (145) should now be glued to the wheels (147), (148). This can be done by using a fast-curing superglue or
!
cyanoacrylate glue available at your hobby shop. Be sure to follow the manufacturer's warnings on the bottle.
Team Losi Tread Lock (A-7880 or A-7881(Thin)) is the best glue available for gluing R/C car tires. This glue was formulated and
produced especially for this pupose.
IMPORTANT NOTE: Allow the glue to dry thoroughly before continuing.
!
Step 5. Press a 3/16" x 3/8" bearing (114) into the inside of both front wheels (147). Slide the front wheels (147) over the front axles
(39) so the solid side of the wheel faces the outside. Slide an axle bearing spacer (115) over the front axle (39) next to the inside
bearing,(114) so that the spacer is positioned in the center of the wheel (147). Press the remaining 3/16" x 3/8" bearings (114) into the
outside of both front wheels (147).
*NOTE: If the 3/16" x 3/8" bearings only have one Teflon
of the wheel.
!
Step 6. Place a 3/16" x .015 shim (149) over each of the front axles (39), next to the outer bearing (114). Secure the front wheels
(147) by threading a 10-32 locknut (150) onto the front axles (39) and tightening with the included Team Losi wheel wrench.
IMPORTANT NOTE: Do not overtighten the front wheel nuts. The front tires should rotate freely.
!
Step 7. Mount the rear wheels (148) to the rear axles (109) by lining up the pins (117) in the rear axles with the grooves in the rear
wheels (148) and pushing the wheels (148) all the way onto the axles (109).
!
Step 10. Secure the rear wheels (148) by attaching 10-32 locknuts (150) to the rear axles (109) and tightening.
114
147
115
114
149
150

BAG F

114 115
144
146
Figure 58
149
TM
seal (colored, woven looking) in them, position the seal to the outside
150
3 1
150
146
148
145