Team Losi XXX-NT Adam Drake Edition Owner's Manual page 47

RADIO INSTALLATION
Figure 100
!
Step 30. For rotary valve carburetors, you will need to re-
move the straight, shorter arm of the throttle servo horn (190), as
shown in Figure 100. Cut off the arm with heavy duty clippers or
TM
a Dremel hobby tool.
Figure 101
!
Step 31. Determine which throttle servo spline insert (200)
will fit your throttle servo by referring to the table on page 3,
Figure 7C.
!
Step 32. Press the correct throttle servo spline insert (200)
into the hexagonal hole in the bottom of the throttle servo horn
(190).
Figure 102
187
!
Step 33. Attach the throttle linkage to the throttle servo horn
by inserting a 2-56 x 1/2" button-head screw (187) through the
over-ride slider (195) and into the inner hole in the longer arm of
the throttle servo horn (190). Once the screw (187) is snug up
against the over-ride slider (195), unscrew it one full turn to allow
some movement between the arm (190) and the slider (195). Se-
cure the screw (187) with a 2-56 locking nut (201).
!
Step 34. Insert the brake linkage Z-bend (197) from the bot-
tom, through the middle hole in the shorter arm of the throttle
servo horn (190).
Rotary Valve Carburetors
201
190
197
44
(Continued)
Figure 100
200
Figure 101
187
201
Figure 102
190
195
190