Team Losi XXX-NT Adam Drake Edition Owner's Manual page 27

Figure 56
!
Step 15. Position the right rear arm (118) inside the rear pivot
block (104) and line up the holes in the arm with the holes in the
pivot. Slide a rear inner hinge pin (122) through the pivot block
(104) and rear arm (118) all the way in until the pin (122) rests
against the set screw in the front of the pivot block (104).
!
Step 16. Repeat step 15 for the left rear arm (119).
Figure 57
33
!
Step 17. Insert two 4-40 x 7/8" cap-head screws (33), one on
each side, through the outer holes in the top of the rear shock
tower (123) from the front side. Secure the screws (33) to the rear
shock tower (123) by threading a 4-40 nut (35) over each screw
!
(33) and tightening..
Use the included Team Losi wheel wrench/nut-driver
to secure the 4-40 nuts.
!
Step 18. Thread a 3/8" ball stud (38) into the center hole on
each side of the shock tower (123).
BAG D (Continued)
122
35
178 178
104
122
33
38
2 4
118
Figure 56
35
123
Figure 57