Team Losi XXX-NT Adam Drake Edition Owner's Manual page 23

Figure 47
96
!
Step 61. Place a 1/4" x .020 washer (96) over each of the two
4-40 x 5/8" set screws (27).
!
Step 62. While holding the brake lever clips (101) in position
on the brake lever (102), slide brake lever clips (101) over the 4-
40 x 5/8" set screws (27). Be sure the top brake lever clip (101)
points tward the rear of the gearbox and the lower brake lever
clip (101) points toward the front.
!
Step 63. Secure the brake lever clips (101) with two 4-40 steel
locknuts (95). Tighten the nuts (95) until they are just snug, then
back them off about 1/4 turn, so the brake lever clips (101) can
still be moved slightly.
!
Step 64. Insert a 3/16" E-clip (103) into the groove in the end
of the brake shaft (77) to retain the brake hub (98).
BAG C (Continued)
103
95
103
77
2 0
102
96
101
96
101
Figure 47
95
95