Figure - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 11

!
Step 22. Attach one end of the rod to the ball stud (11) in the
servo arm (22) and the other to the ball stud (11) in the servo
saver top (3) as shown in Figure 11.
Figure 12
!
Step 23. Press a rubber tank-mounting grommet (28) into
each of the three large holes in the top of the chassis brace (29) as
shown. The grommets (28) should be centered, top-to-bottom, in
the holes of the chassis brace.
Figure 13
17
!
Step 24. Line up the three posts on the fuel tank (30) with the
three holes with grommets in the chassis brace (29). Install the
fuel tank (30) on the chassis brace (29) from the bottom by press-
ing the three posts on the tank (30) through the three rubber
grommets (28).
!
Step 25. Place a #4 washer (23) over each of the three 4-40 x
3/8" cap-head screws (17). Thread a screw (14) through each of
the grommets (28) and into the posts in the fuel tank (28). Hold
the tank (30) all the way up against the chassis brace (29). Tighten
each of the three screws (14) until the washer (23) just touches the
grommet (28).
*NOTE: The screws should not be tightened so that grommet
smashes. By tightening the screws until the washers just touch the
grommets, the tank will be "shock mounted". This helps the fuel
from foaming while running the truck.
BAG A (Continued)
28
23
11
17
23
29
30
5
22
28
29
28