Team Losi XXX-NT Adam Drake Edition Owner's Manual page 16

Figure 30
63
!
Step 7. Insert a 5mm x 8mm bearing (63) into the center of
the diff gear (64).
!
Step 8. Press a 3/32" carbide diff ball (65) into each of the
small holes in the diff gear (64).
IMPORTANT NOTE: There are two sets of diff balls
in Bag C. Be certain to use the slightly larger balls that are pack-
aged alone (12 total) in Figure 30, Step 8. There is a second set of
eight 5/64" balls packaged with washers in the bag. These balls
will be used in Figure 32.
Figure 31
!
Step 9. Apply a fairly heavy coat of clear diff grease (62) to
the exposed side of the diff washer (61). Carefully place the diff
gear (64) over the male outdrive (60) so that the diff balls (65)
and diff gear (64) rest against the diff washer (61).
Figure 32
58
67
!
Step 10. Locate the diff adjusting screw (67) and place the
foam thrust bearing seal (68) over the shoulder of the screw (67).
!
Step 11. Place one beveled washer (58) over the diff screw
(67) with the concave surface facing away from the head of the
diff screw (67).
!
Step 12. Place one of the 3mm x 8mm thrust bearing
washers (69) over the diff screw (67).
*NOTE: The thrust bearing washers are packaged in a small
bag along with the eight 5/64" thrust bearing balls.
!
Step 13. Grease the thrust washer (69) well with white thrust
bearing/assembly grease (71) and place the eight 5/64" thrust bear-
ing balls (70) on top of the washer (69), around the diff screw (67).
Apply more white thrust bearing/assembly grease (71) to the tops
of the thrust bearing balls (70). Place the second thrust washer
(69) over the screw (67) and against the thrust bearing balls (70).
!
Step 14. Very carefully insert the diff screw (67), with the
thrust bearing assembly installed, into the female outdrive (66).
Pull the threaded end of the diff screw (67) until the thrust bear-
ing assembly rests against the inside of the outdrive (66).
IMPORTANT NOTE: Ensure that all eight thrust bear-
ing balls remain in place between the two washers, around the diff
screw.
BAG C (Continued)
65
70
68 69
63
64
65
60
GREASE
69
GREASE
1 3
65
Figure 30
64
61
Figure 31
66
70
58
68
67
Figure 32