Bag C - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 26
!
Step 1. Insert a 4-40 mini locknut (7) into the hex area of the
diff nut carrier (57). The thread-locking portion of the nut (7)
should be to the outside.
Figure 27
!
Step 2. Locate the 5/64" Allen wrench (59) supplied with the
kit. Place the diff nut carrier (57), nut side first, over the Allen
wrench (59).
!
Step 3. Stack 12 beveled washers (58) over the wrench, next to
the diff nut carrier (57). The washers (58) should all point the same
direction with the concave side facing away from the diff nut carrier
as shown in Figure 27A.
Figure 28
!
Step 5. Insert all of the parts that are stacked on the wrench
into the male outdrive/diff half (60). Line up the tabs on the diff
nut carrier (57) with the slots in the outdrive (60). Press the parts
all the way into the outdrive/diff half (60).
Figure 29
!
Step 6. Apply a small amount of diff grease (clear) (62) all
the way around the face of the outside ridge of the outdrive/diff
half (60). Attach a diff washer (61) to the outdrive (60) by center-
ing the hole in the washer (61) over the raised center of the outdrive
(60).
*NOTE: Only a small amount of grease is needed, but be
sure to cover the entire face of the ridge on the outdrive.
IMPORTANT NOTE: Do not glue the diff washers to
the outdrive/diff halves. Doing so may not allow the washers to
mount flat.

BAG C

7
58
61
7
Belleville washers should be stacked like this
61
60
1 2
57
Figure 26
58
57
Figure 27A
60
Figure 28
APPLY
GREASE
HERE
Figure 29
59