Team Losi XXX-NT Adam Drake Edition Owner's Manual page 52

RADIO INSTALLATION
Figure 112
!
Step 42. Turn your transmitter switch on followed by the receiver switch (or plug in the extension wire if not using a switch).
!
Step 43. Move the transmitter throttle control to full throttle. The throttle servo should open the carbuertor and push backward on
the brake lever. If the servo rotates the wrong direction, refer to your radio manufacturer's instructions for reversing the servos.
!
Step 44. With the throttle control on the transmitter in the neutral position and the trim centered, check that the carburateor
opening is in the fully closed position, and that the springs (194)(196) on the throttle wire (191)(203) are compressed the same amount.
If the carburetor is not fully closed, or one spring (194)(196) is compressed much more than the other, adjust the position of the over-
ride slider (195) by moving the collars (192) along the wire (191)(203), one at a time, until the slider (195) is centered between the
springs (194)(196), and the carburetor is in the closed position. This will be the correct idle position.
!
Step 45. With the throttle still in the neutral position and the carburetor fully closed, check to see that the collar (192) at the front
of the brake over-ride slider (195) is not touching the slider (195). If it is, loosen the setscrew (193) and move the collar forward so that
it does not touch the over-ride slider (195) while the brake lever (102) rests in the forward position against the brake caliper. Loosen the
setscrew (193) in the collar (192) at the rear of the brake linkage wire (197) and move the collar (192) until the linkage spring (196) has
a slight amount of pre-load on it. Tighten the setscrew (193) in this collar (192).
*NOTE: This collar can be adjusted later to change the amount of "panic", or full brake that the truck has.
!
Step 46. Loosen the setscrew (193) in the collar (192) at the front side of the brake over-ride slider (195) and move the collar (192)
until it just touches the slider (195). Tighten the setscrew (193) in the collar (192). This will be the final location of this collar (192).
!
Step 47. Move the throttle control on the transmitter to full throttle. Refer to the radio manufacturer's instructions and adjust the
end point adjustment so the throttle servo will rotate just far enough to open the carburetor all the way. Now move the throttle control
on the transmitter to full brake. Adjust the end point on the transmitter so that the servo doesn't over-rotate when applying full brake.
The servo should only have to move 3/8" in the brake direction.
*NOTE: If your radio system does not have end point adjustments, you may need to move the throttle pivot and brake linkage wire to a different hole
in the servo horn. The closer the wires are mounted to center on the horn, the less the wires will move. If the wires are moved to a different hole in the
servo horn, start the throttle linkage adjustment again at Step 43.
ROTARY VALVE INSTALATION
192
192
196
195
192
Figure 112A
192
195
196
SLIDE VALVE INSTALATION
192
194
196
195
49
(Continued)
192
192
197
Figure 112B
194
196
195
192