Team Losi XXX-NT Adam Drake Edition Owner's Manual page 22

Figure 44
27
!
Step 52. Press the .078" x 3/8" spirol pin (78) into the hole in
the end of the brake shaft (77) so that it extends evenly from both
sides of the shaft (77).
!
Step 53. Slide the brake hub (98) over the brake shaft (77).
Align the groove in the brake hub (98) with the pin (78) and slide
the hub (98) over the pin (78).
!
Step 54. Thread the two 4-40 x 5/8" set screws (27) all the
way into each of the two brake caliper mounting holes in the left
gearbox half (83).
!
Step 55. Slip a 1/4" x .020 washer (96) and a brake sleeve (97)
over each of the two 4-40 x 5/8" set screws (27).
Figure 45
!
Step 56. Place one of the brake caliper plates (99) over the
two brake sleeves (97).
!
Step 57. Slide the brake rotor (100) onto the brake hub (98).
!
Step 58. Place the other brake caliper plate (99) over the
brake sleeves (97).
Note: Continue with Step 61/Fig. 47
BAG C (Continued)
78 96
78
83
1 9
77
27
27
96
Figure 44
97
99
97
98
Figure 45
96
97
98
97
99
100