Team Losi XXX-NT Adam Drake Edition Owner's Manual page 17

Figure 33
63
!
Step 15. Locate the smallest of the Allen wrenches (59) and
place it through the slot in the outdrive/diff half (66) containing
the diff screw (67). Slide the wrench all the way against the screw
(67). By handling the outdrive/diff half (66) with the wrench
inserted, the diff screw (67) will be held in place while finishing
assembly of the differential.
!
Step 16. Insert a 5mm x 8mm bearing (63) into the female
outdrive/diff half (66). Make sure that the bearing (63) is pushed
all the way into the outdrive (66).
!
Step 17. Apply a small amount of diff grease (clear) (62) all
the way around the face of the outside ridge of the outdrive/diff
half (66). Attach a diff washer (61) to the outdrive (66) by center-
ing the hole in the washer (61) over the raised center of the outdrive
(66).
*NOTE: Only a small amount of grease is needed, but be
sure to cover the entire face of the ridge on the outdrive.
Figure 34
!
Step 18. Apply a fairly heavy coat of clear diff grease (62) to
the exposed side of the diff washer (61).
!
Step 19. While holding the outdrive/diff half (66) with the
Allen wrench inserted, carefully place the two outdrive/diff halves
(60)(66) together.
!
Step 20. Make sure that the slot in the diff screw (67) is lined up
with the slot in the outdrive/diff half (66) and that the Allen wrench is
inserted in the slot in the diff screw (67).
!
Step 21. Hold the diff so that the outdrive/diff half (60) with the
diff nut carrier (57) is pointing up. Slowly turn the top diff half clock-
wise to thread the diff screw (67) into the 4-40 mini locknut (7) in the
diff nut carrier (57). Thread the two halves together until the screw
just starts to snug up.
*NOTE: If the screw will not thread into the nut, make sure
that the diff nut carrier is pushed all the way into the outdrive/diff
!
half.
When tightening the diff, tighten the screw a little and
then "work" the diff a little. Then tighten the diff a little more and
"work" the diff again. Continue this until the diff is tight. This
will ensure proper seating of all the parts in the diff
assembly.
!
Step 22. Tighten the diff until the gear (64) cannot be turned
while both of the outdrives (60)(66) are being held. Final diff
adjustment should be made after completion of the car.
BAG C (Continued)
61
63
GREASE
66
60
64
61
59
1 4
61
Figure 33
57
66
Figure 34
67