Team Losi XXX-NT Adam Drake Edition Owner's Manual page 28

Figure 58
9
!
Step 19. Place the rear shock tower (123) over the rear of the
gearbox assembly (82)(83) so that the top holes line up. Place a
gold ball stud washer (9) over each of the 4-40 x 1/2" cap-head
screws (31). Secure the rear shock tower (123) to the gearbox
(82)(83) by threading the 4-40 x 1/2" screws (31), with washers (9)
attached, throught the tower (123) and into the gearbox (82)(83).
Figure 59
124
!
Step 20. Apply a little of the white grease found in Bag A on the
threads of the turnbuckles (55) Note that the ends of the turnbuckles
are threaded opposite, one end with left the other with right hand
threads. This allows the the length to be adjusted after they are in-
stalled. Thread a long plastic rod end (54) onto each end (one will
thread on clockwise, the other end counter clockwise) equally until
the rod is the same length as the rode shown in figure 59A. Make two
of these assemblies.
BAG D (Continued)
31
9
82
2 5
31
Figure 58
Figure 59A
Figure 59
123
83