Team Losi XXX-NT Adam Drake Edition Owner's Manual page 43

RADIO INSTALLATION
Figure 92
!
Step 8. Place the battery pack into the battery box (125), so
that the power lead is to the right side of the chassis. Cut two
small pieces of the battery spacer foam (185) to fit inside the
battery box (125) on each side of your battery pack. The foam
(185) should fit tightly between the battery pack and the sides of
the battery box (125) to prevent the battery pack from moving
around inside the box while running your truck.
!
Step 9. Attach the battery box lid (186) to the battery box
(125) with four 2-56 x 1/2" button-head screws (187). Be carefull
not to pinch the power lead in between the battery box (125) and
the lid (186).
*NOTE: If your battery pack is smaller and fits loosely under
the lid, cut a piece of battery spacer foam to fit tightly between
the lid and the battery pack. This will keep the battery pack from
moving up and down in the battery box.
!
Step 10. Route the power lead forward through the shock
tower and over the gearbox.
Figure 93
!
Step 11. The top holes in the throttle servo mounts (188) are
offset slightly to accomodate different width servos. Look up your
throttle servo in the table on page 3, Figure 7C to determine
what configuration to assemble the throttle servo mounts (188).
The "WIDE" configuration is shown in Figures 93A and the "NAR-
ROW" configuration is shown in Figure 93B.
!
Step 12. Attach the throttle servo mounts (188) to the chassis
(19) with two 4-40 x 3/8" flat-head screws (20), so that the mounts
are oriented correctly, as shown in Figure93A or 93B.
TOP HOLES WIDE
Figure 93A
TOP HOLES NARROW
Figure 93B
187
20
185
125
188
20
40
(Continued)
186
187
185
Figure 92
19
Figure 93