Team Losi XXX-NT Adam Drake Edition Owner's Manual page 14

Figure 24
54
!
Step 24. Apply a little of the white grease found in Bag A on the
threads of the turnbuckles (55) Note that the ends of the turnbuckles
are threaded opposite, one end with left the other with right hand
threads. This allows the the length to be adjusted after they are in-
stalled. Thread a long plastic rod end (54) onto each end (one will
thread on clockwise, the other end counter clockwise) equally until
the rod is the same length as the rode shown in figure 24A. Make two
of these assemblies.
Figure 25
!
Step 25. Snap one end of a completed tie rod assembly to the ball
stud (11) in the steering idler arm (8). Snap the other end to the ball
stud (10) in the right spindle (40). Attach the other tie rod assembly to
the ball stud in the bottom of the servo saver assembly (8) and the left
!
spindle (41).
Once again, assure that all turnbuckles are mounted with
the threads in the same direction for easier adjustment later.
BAG B (Continued)
55
54
8
11
1 1
55
Figure 24
Figure 24A
10
Figure 25
40