Final Assembly - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 114
!
Step 1. Trim the body (205) along the trim lines as shown. Cut out the areas indicated on the front and side windows to allow easy
access to the fuel tank. Cut out the area behind the cab to allow for cooling and access to the engine.
!
Step 2. Make three 5/16" (8mm) diameter holes in the areas on the windshield and hood of the body (205) that are marked with
dimples or small circles.
!
Step 3. Make two 5/16" (8mm) diameter holes in the rear of the body at the locations marked with a small hole or dimple.
!
Step 4. Cut the spoiler out of the back panel and attach it to the body with double sided tape.
!
Step 5. Attach the body (182) to the truck and secure it by placing a body clip (184) through each of the two holes in the front body
mount (12), and the two holes in the rear shock tower (96).
205
Body Painting
Prepare the body shell for painting by washing it thoroughly with warm water and a small amount of liquid detergent. Dry the body
with a clean, soft cloth. Use the window masks (185), supplied with the kit, to cover the window areas from the inside. A high-grade
masking tape should be used on the inside of the body to mask off any stripes, panels, or designs that you wish to paint on the body. Use
acrylic lacquer, acrylic enamel, or any other Lexan (Polycarbonate) recommended paints. Apply paint to the inside of the body.
Remove the tape for the area that you wish to apply the next color to and continue with the next color. Try to use the darker colors first.
If you use a dark color after a light color, apply a thin coat of white over the lighter color before continuing with the darker color.
Stickers
The stickers are pre-cut for your convenience. Before removing a sticker, find the desired location for it. Remove the sticker with a hobby knife
and position it above the desired location and press it firmly into place to complete its application.

FINAL ASSEMBLY

Figure 114
51