Team Losi XXX-NT Adam Drake Edition Owner's Manual page 11

Figure 17
9
!
Step 6. Attach the front shock tower (34) to the front bulk-
head (32) with four 4-40 x 3/8" cap-head screws (17). The screws
(17) thread into the top-most and bottom-most holes in the bulk-
head (32). The center holes are not used.
IMPORTANT NOTE: The screws in the top of the shock
tower must be pointing forward as shown in Figure 17.
!
Step 7. Place a ball stud washer (9) over each of the two 3/8" ball
studs (38). Thread a 3/8" ball stud (38) into the outside hole on each
side of the front bulkhead (32).
Figure 18
44
!
Step 8. Insert a front axle (39) into each of the front spindles
[right (40), left (41)] as shown. The hole in the axle (39) should
line up with the hole in the spindle (40), (41).
!
Step 9. Attach the right spindle (40) to the right spindle car-
rier (42) by aligning the holes in each part and inserting a 1/8" x
1.250" king pin (44) from the bottom. Do not insert the pin all the
way through both parts yet.
!
Step 10. Insert a front spindle spacer (45) between the top of
the spindle (40) and the spindle carrier (42) as shown in Figure
18. Once the spacer (45) is in place, insert the king pin (44) through
the spacer (45) and the top of the spindle carrier (42).
!
Step 11. Center the king pin (44) and secure it with two 1/8"
E-clips (46). With the king pin (44) still centered, thread a 5-40
setscrew (47) into the back side of the axle (39) and tighten.
!
Step 12. Repeat Steps 8-11 for the left spindle (41) and left
spindle carrier (43).
BAG B (Continued)
17
38
46
47
40
39
8
34
Figure 17
45
42
44
47
46
Figure 18
38
17
9
32