Figure 5 - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 43
!
Step 44. Slide the slipper backing plate (89) over the slipper shaft (73), aligning the flat sections on the slipper shaft (73) with the
flat sections of the backing plate (89).
!
Step 45. Place the slipper pad (90) on one side of the spur gear (91) and align the notches on the spur gear (91) with the notches on the
slipper pad (90).
!
Step 46. Place the spur gear (91), pad side first, over the slipper shaft (73). The slipper pad (90) should rest against the slipper back plate (89).
*NOTE: Ensure that the notches in the slipper pad remain indexed in the spur gear.
!
Step 47. Install the second slipper pad (90) to the exposed side of the spur gear (91). Again, align the notches on the spur gear (91) with the
notches on the slipper pad (90).
!
Step 48. Place the second slipper backing plate (89) over the slipper shaft (73) so that the large, flat surface of the backing plate (89) rests
against the slipper pad (90).
!
Step 49. Slide the slipper spring adaptor (92), large side first, onto the shaft (73) and against the outer slipper backing plate (89).
!
Step 50. Place the silver slipper spring (93) over the shaft (73), followed by the spring retaining washer (94), small side first, and secure with
the 4-40 steel locknut (95).
IMPORTANT NOTE: Before tightening the nut, check to see that the slipper pads are properly aligned with the spur gear on both
sides. If not, align them before proceeding.
!
Step 51. Tighten the 4-40 locknut (95) all the way down, and then back it off five full turns (e.g., 360
adjustment. Final adjustment can be made later.
93
94
95
BAG C (Continued)
93
90
89
92
94 95
89
90
91
Figure 43
1 8
o
x 5). This is a good starting point for
73
72