Team Losi XXX-NT Adam Drake Edition Owner's Manual page 49

RADIO INSTALLATION
Figure 105
!
Step 24. Thread the 4mm ball cup (204) all the way onto the
end of the threaded throttle rod (203). Slide a linkage collar (192)
over the other end of the throttle rod (203), and up against the
ball cup (204). Secure the collar (192) with a 4-40 x 1/8" set screw
(193).
!
Step 25. Place the throttle over-ride spring (194) (longer of
the two springs) over the rod (203) and against the collar (192).
Slide a plastic over-ride slider (195) onto the rod (203), so that the
long end is away from the ball cup (204).
!
Step 26. Place a brake over-ride spring (196) (black, shorter
of the two springs) over the rod (203) and against the over-ride
slider (195). Place a linkage collar (192) over the end of the rod
(203), so the springs are somewhat compressed, and secure it with
a 4-40 x 1/8" setscrew (193). The collar (192) should be posi-
tioned at the end of the rod (203). Final adjustments will be made
later.
Figure 106
!
Step 27. Slide a linkage collar (192) over the end of the long,
brake Z-bend wire (197), and position it approximately 3" (75mm)
from the Z-bend. Secure the collar (192) in place with a 4-40 x
1/8" set screw (193).
!
Step 28. Slide a plastic over-ride slider (195) onto the wire
(197), so that the long end is towards the Z-bend. Place a brake
over-ride spring (196) (black, shorter of the two springs) over the
wire (197) and against the slider (195).
!
Step 29. Slide a linkage collar (192) over the end of the wire
(197) until it just touches the spring (196). Secure it with a 4-40 x
1/8" setscrew (193). Once again, final adjustments will be made
later.
Slide Valve Carburetors
NOTE:
If your engine comes equipped with a slide valve carburetor, complete the
steps in Figure 105 through Figure 111.
193
193
193
204
203
193
196
192
195
46
(Continued)
192
195
194
196
Figure 105
193
197
192
Figure 106
193
192