Team Losi XXX-NT Adam Drake Edition Owner's Manual page 29

Figure 60
!
Step 21. Attach one end of the rear camber link assembly
from Step 19 to the ball stud (38) in the right rear hub (112) and
!
the other end to the ball stud (38) in the rear shock tower (123).
Remember to attach the turnbuckles so that the threads
are in the same direction on all your linkages.
!
Step 22. Repeat Step 20 for the left side of the truck.
*NOTE: It's a good idea to leave your truck sitting on a flat
surface until the shocks are assembled and installed. This will
keep the dogbones in place.
Figure 61
9
!
Step 23. Slide the battery box (125) into place on the back of
the chassis (19). The top flange of the battery box (125) should fit
between the shock tower (123) and the gearbox. The back of the
chassis (19) should fit snug into the recess in the bottom of the
battery box (125). Be sure that all the holes line up.
!
Step 24. Place a gold ball stud washer (9) over each of the 4-
40 x 1/2" cap-head screws (31). Secure the rear shock tower (123)
and battery box (125) to the gearbox by threading the 4-40 x 1/2"
screws (31), with washers (9) attached, throught the tower (123)
and battery box (125) and into the gearbox.
!
Step 25. Secure the bottom of the battery box (125) to the
chassis (19) with two 4-40 x 1/2" flat head screws (36).
BAG D (Continued)
36
31
38
113
125
2 6
123
Figure 60
31
9
20
Figure 61
123
19