Team Losi XXX-NT Adam Drake Edition Owner's Manual page 18

Figure 35
!
Step 23. Locate the slipper shaft (73) and thread the 4-40 x 1"
setscrew (72) all the way into the threaded side of the slipper shaft
(73). Make sure that the setscrew (72) is TIGHT!
*NOTE: Some top gear/slipper shaft assemblies may be pre-assembled
!
from the factory.
A small amount of liquid thread-lock should be used
to help to hold the setscrew securely in place. If your slipper
shaft was pre-assembled at the factory, thread-lock compound
has already been applied.
Figure 36
74
!
Step 24. Press the 1/16" x 5/16" pin (74) into the small hole in
the slipper shaft (73) so that it extends evenly from both sides of
the shaft (73).
!
Step 25. Slide the top gear (75) over the setscrew (72) onto
the slipper shaft (73). Align the groove in the gear (75) with the
pin (74) and slide the gear (75) over the pin (74).
!
Step 26. Secure the top gear (75) to the shaft (73) by inserting
a 3/16" C-clip (76) into the groove in the slipper shaft (73).
Figure 37
76
!
Step 27. Locate the brake shaft (77) and press the .078" x 3/8"
spirol pin (78) into the small hole away from the grooved end of
the brake shaft (77) so that it extends evenly from both sides of
the shaft (77).
!
Step 28. Press the compound gear bushing (181) all the way
into the end of the compund gear (79). Slide the compound gear
(79), with the bushing (181) in place, over the brake shaft (77).
Align the groove in the gear (79) with the pin (78) and slide the
gear (79) over the pin (78).
!
Step 29. Secure the compound gear (79) and bushing (181) to
the shaft (77) by inserting a 3/16" C-clip (76) into the groove in
middle of the brake shaft (77).
BAG C (Continued)
72
76
78
72
76
76
78
1 5
73
Figure 35
73
74
Figure 36
79
77
Figure 37
75
181